/ / How to remove polident denture adhesive cream

How to remove polident denture adhesive cream?

Not having to worry about your dentures (commonly called false teeth) sitting tight leaves you free to deal with the more important things in life. If you’re after 3D hold with a natural feel, look no further.

Polident Fresh Adhesive gives you 3D hold, and is free from zinc.

Using Polident Fresh Adhesive

Applying

  1. Clean and dry your dentures.
  2. Apply a small amount of Polident Fresh Adhesive in short strips (see diagrams), not too close to denture edges.
  3. Rinse mouth before inserting dentures.
  4. Press firmly into place, hold firmly, and bite down for a few seconds to secure.
  5. Do not apply more than once a day.

Removing

  1. Swish mouth with water.
  2. Slowly remove dentures using a rocking motion.
  3. Remove adhesive residue from dentures and mouth with warm water and a soft denture brush.
  4. Use Polident denture cleanser to thoroughly clean your denture.

Refer to pack instructions

Did you find this page helpful? Share it

©2018 GlaxoSmithKline Consumer Healthcare Australia Pty Ltd (ABN 68 603 310 292) All rights reserved. Trade marks are owned or licensed by the GSK Group of Companies.
©2018. GSK group of companies or its licensor.

The content of this website is intended for Australia audiences only.

©2018 GlaxoSmithKline Consumer Healthcare Australia Pty Ltd (ABN 68 603 310 292) All rights reserved.

POLIDENT is a registered trade mark of the GSK group of companies or its licensor.

The content of this website is intended for Australia audiences only.


Comments 0 Add a comment